SD2Iec Firmware v0.9.0 Released
SD2IEC is a hardware mass storage device using an SD/MMC card and interfacing with the IEC bus. It is based on the ATmega644 microcontroller from the Atmel AVR microcontroller family.
The most prominent use of SD2IEC is emulation/replacement of a Commodore-1541 disk drive for a C64. Hardware and the microcontroller’s firmware is available as open source (GPL).
Changelog:
2009-02-28 – release 0.9.0
- Bugfix: REL offset calculation for records 256,512,…
- Bugfix: Non-REL P command parameters now match README.
- Bugfix: Reading after EOI behaves correctly now.
- Red LED only active while unwritten data in memory.
- Remove XC,XJ commands.
- New fastloader: ULoad Model 3.
- New fastloader: G.I. Joe (said to be commonly ripped)
- New fastloader: Epyx FastLoad cartridge.
- Support reading raw directory ($ with secondary > 0)
- “display disk images as directories”-mode.
- DNP support.
- Remote display support.
- Build system doesn’t require gawk anymore.
source: sd2iec.de gitweb forum thread c64-wiki
Categories: Firmware, News & Rumors, Today
Recent Comments