SD2Iec Firmware v0.8.1 Released
SD2IEC is a hardware mass storage device using an SD/MMC card and interfacing with the IEC bus. It is based on the ATmega644 microcontroller from the Atmel AVR microcontroller family. The most prominent use of SD2IEC is emulation/replacement of a Commodore-1541 disk drive for a C64.
Hardware and the microcontroller’s firmware is available as open source (GPL).
Changelog:
2009-05-20 – release 0.8.1
- Fix uIEC/IDE SD card change detection.
- Dreamload support for uIEC.
- Mark the RTC time as valid after setting the clock.
- Delay SPI initialisation until absolutely required.
- Show disk change confirmation even when the error blink is active.
- Exit the FC3 fastloader if ATN is active.
- Fix indentation of 1000+ block files.
- Remove 0-byte from the long version message.
- Fix multiple save-with-replace bugs.
- Ignore directories when matching file name wildcards.
source: sd2iec.de gitweb forum thread c64-wiki
Categories: Firmware, News & Rumors, Today
SD2IEC is a wonderful creation. Thanks for sharing it.
yep, i have link your project ‘sd2iec inside cassette case’ .. very nice project.