2 x Atari Lynx II Repair and Recap.
The first Atari Lynx II did not turn on but when powering the console at 5v bypassing the power stage it worked properly.
I had to replace all the electrolytic capacitors and the critical components of the power stage.
- 1 x MOSFET MTDJ055E with a equivalent one.
- 2 x Transistor 2N3906.
- 1 x Zener Diode 1N5991B.
- 1 x 120 Ohm resistor.
The second Atari Lynx II working correctly so consequently i have only replaced the electrolytic capacitors.
Gallery of the repair:
Why make a Retr0Bright if you have a 130XE (mint) to sacrifice to replace the yellowed case and keyboard of an Atari 800XE ?
If we talk about collecting an atari 800XE is more important than a 130XE, especially if you have more than one.
I have replaced only the upper side of the case, the keyboard and the plastic piece of the led which in the 800XE is white and not red, the back side with the adhesive fortunately was in perfect condition.
I didn’t have to do any repairs except to calibrate the XC12 cassette recorder motor speed using an old but still valid speed calibration system, a music cassette, obviously only if you have a “good ear” and you know the music track perfectly.
NOTES: i have never seen the XC12 in a white box and miss it in my Atari collection.
NOTES 2: How did i listen the Billy Idol cassette? the Atari SIO connector supports Analog audio with a dedicated pin to this purpose.
Gallery:
The Atari XE Video Game System (Atari XEGS) is a home video game console released by Atari Corporation in 1987.
Based on Atari’s 8-bit 65XE computer, the XEGS is compatible with the existing Atari 8-bit computer software library. Additionally, it is able to operate as either a stand-alone console or as a full computer with the addition of its specially designed keyboard.
In computer mode, it may utilize the majority of peripherals released for Atari’s 8-bit computer line. Atari packaged the XEGS as a basic set consisting of only the console and joystick, and as a deluxe set consisting of the console, keyboard, joystick and light gun.
Gallery:
source: wikipedia
Everything seems to work perfectly including Hard Disk and Floppy Drive.
I must thank my friend Ralf Schmitz for this gift.
Gallery:
Thanks to my friends Charlie and Gerben for this fantastic gift which adds another piece to my Atari Collection that now begins to become respectable.
This version of the Atari 410 Cassette Recorder differs from the one inside the “Atari – The Educator” box only for the additional colored box that hold the simple one in white cardboard.
Gallery:
The Atari 820 printer provided Atari 400/800 users with a quick and simple printer. No drivers or special interfaces were needed.
The Atari 820 printer plugged directly onto the Atari SIO bus and allowed users the ability to make 40 column printouts which were good for tracking finances, printing out program listings and other files. The printer made an interesting sound which could only be described as a washing machine.
Gallery:
source: atarimuseum.com
Soft Carry Cover for Atari 1050 Disk Drive.
Gallery:
The Atari 2600 (or Atari Video Computer System before November 1982) is a home video game console by Atari, Inc. Released on September 11, 1977, it is credited with popularizing the use of microprocessor-based hardware and ROM cartridges containing game code, a format first used with the Fairchild Channel F video game console in 1976. This format contrasts with the older model of having non-microprocessor dedicated hardware, which could only play the games that were physically built into the unit.
For five years, 1977 until late 1982, the system was officially sold as the Atari VCS, an abbreviation for Video Computer System. Following the release of the Atari 5200 in November 1982, the VCS was renamed to the “Atari 2600″, after the unit’s Atari part number, CX2600. The 2600 was typically bundled with two joystick controllers, a conjoined pair of paddle controllers, and a game cartridge: initially Combat, and later Pac-Man.
Gallery:
source: wikipedia
A paddle is a game controller with a round wheel and one or more fire buttons, where the wheel is typically used to control movement of the player object along one axis of the video screen.
A paddle controller rotates through a fixed arc (usually about 330 degrees); it has a stop at each end.
The Atari CX40 joystick was the first widely used cross-platform game controller. The original CX10 appeared on the Atari 2600 in 1977, and was considered such a great advance over other controllers that it became the primary input device for most games on the platform. The CX10 was replaced after a year by the much simpler and less expensive CX40. The addition of the Atari joystick port to other platforms cemented its popularity, and millions were produced and used on almost every game console and home computer of the era.
The CX40 was so popular during its run that it became as iconic for Atari as its “Fuji” it remains a common staple in video game iconography to this day, and is commonly referred to as the symbol of 1980s video game system design. The CX40 has been called “the pinnacle of home entertainment controllers in its day”, and remains a staple of industrial design discussions.
source: wikipedia
Of all of the Joysticks Atari ever made over the years they were in business, our two least favorite Atari controllers were the 7800 CX24 Slim line Deluxe Joystick (sometimes called the Atari Proline Joystick) and the ill fated Atari Space Age Joystick, which had an internal flex circuit problem from the start and caused it to be dropped by Atari very fast. Now Atari Space Age Joysticks are a very rare Atari collector item.
The main reason why the Atari CX24 dual fire button Joystick was not one of our favorite Atari controllers made, was the left, right fire button PCB’s and Main X / Y PCB would fail very fast. 1st the left and right fire buttons PCBs would fail and second the main X / Y PCB would fail next with any kind of normal use.
You can read more about this joystick here
The Atari Trak-Ball is a pointing/movement device consisting of a ball held by a socket containing sensors to detect a rotation of the ball about two axis-like an upside-down mouse with an exposed protruding ball. The user rolls the ball with the palm of the hand while using the fingertips to press the two large buttons.
The Atari Track-Ball is mainly used with games like Centipede, Missile Command, Crystal Castle, etc.
Gallery:
The Atari Tape Recorder Model XC11 can save or load programs/data from magnetic media (audio cassette).
The transfer rate is 600bits per second, so you can record about 100,000 bytes of data on a regular 60 minute cassette.
Unlike the new XC12 model in the XC11 we find the SIO pass through connector so this device can be connected anywhere in the SIO chain.
The power is supplied from the I/O Serial cable (SIO).
Gallery:
Recent Comments